Installing Your Whisp Scent Platform

Follow these quick steps to mount, connect, and prepare for first use.

Before You Begin

You’ll need:

  • Drill and wall anchors, depending on mounting location.
  • ¾″ hole saw or step drill bit
  • HVAC foil tape or plumber’s putty
  • A screwdriver and level

Things to know:

  • The scent distribution line is the large tube which carries the diffused scent to HVAC system
  • The scent supply line is the smaller tube which carries essential oil from the bottle into the atomizer

Step 1: Choose Your Mounting Location

  • Pick a spot close to ductwork, with an accessible power outlet.
  • Keep the device upright and away from moisture or direct sunlight.

Step 2: Mount Securely

  • Mount the device close to your HVAC main air supply. You may choose to mount it to a wall or place it on a flat, elevated surface nearby.
  • Once the location of the unit has been decided, double-check that the tube length of the larger tubes will reach the main air supply duct with an additional 6 inches to allow for secure insertion into the duct.

Step 3: Drill and Connect

  • Drill a hole (approximately 5/8" to 3/4") in the main air supply duct of your HVAC system where the scent distribution line will go
  • Insert the scent distribution line and seal around it using foil tape or plumber's putty
  • Attach the scent distribution line to your Whisp’s outlet port
  • If you have the Whisp 50 or Whisp 150, you will also need to connect the smaller scent supply line from the external essential oil canister(s) to the scent platform.

Step 4: Power On

Connect the DC adapter, turn on the switch, and your Whisp is ready for programming.

Back to blog